fv1-vscode

• Create a new block diagram from a template, browsed by category and pulled from the easy-spin-effects GitHub repository
• Pots in the simulator are now labelled automatically for a .spndiagram, from what each pot is wired to — including through Smoother and other control-shaping blocks, so a pot feeding a delay through a smoother reads "Delay Time" rather than "CV In"
• Bump fv1-core and easy-spin-ui. Block changes worth knowing about:
  • Two new blocks: Allpass (four cascaded diffusers, the building block of a reverb) and Chirp (up to 30 identical all-passes for spring-style dispersion)
  • Fixed: 4-Voice Chorus swept twice the LFO Width you set, which ran the modulated taps off the end of its delay line at wider settings
  • Fixed: Pitch Shift ignored its Semitones setting entirely — every value produced the same shift, and negative values played backwards
  • Fixed: the Flanger's second output is now the unmodulated centre tap it was meant to be, instead of a fixed tap at the far end of the delay line
  • New controls: Shimmer Reverb Diffusion and Wet Level, Octave Up & Down Buffer Size, Harmonic Tremolo Band Mode and a Frequency CV input
  • Mix controls on Simple Reverb and Shimmer Reverb no longer change loudness as you sweep them
  • Programs use less delay RAM: memory for a block stage that is switched off is no longer reserved
  • A DAC block with a gain no longer costs an extra instruction

• Pick up latest fv1-core with a fix to the simulator related to the COMPA flag on cho rda
• Mixer blocks are slightly more efficient

This release picks up the latest fv1-core and easy-spin-ui with a fix to the simulator related to LFOs. The ramp_lfo block has also changed (it actually works properly now), and it also removes the useless WLDR amplitude setting.

Bump fv1-core

Support for opening .spnbank files in the simulator Minor improvements

Bump fv1-core and release

• Support for exporting a bank to HEX
• Support for reading from a pedal (and a disassembler)
• Dynamic POT labels in the simulator
• A bunch of other goodies....

• Pick up latest fv1-core with small fix to chorus and flanger blocks for CV consistency
• Remove redundant and broken resource pills in the block diagram editor

Bump fv1-core to pick up some more fixes, particularly in the ramp_lfo block

• Pick up latest fv1-core (0.6.14) with a major block audit
  • Unified Mix behaviour: all Mix controls now use a constant-power crossfade, holding level flat across the sweep instead of dipping ~3 dB in the middle (Bit-Mangler, Chiptune, Guitar Synth, Organ Synth, Auto Wah)
  • Headroom fixes: Organ Synth drawbars are now normalised (previously distorted at every usable input level), Spring Reverb and 2-Pole SVF no longer clip internally, Room Reverb output level matched to the other reverbs
  • Blocks that were partly or wholly inert now work: Chiptune's noise channel and ring modulator, the Ramp LFO, and Ducking Reverb's Sensitivity control
  • CV controls now consistent: a connected CV scales within the parameter's value rather than replacing it. Note: patches driving the Sin/Cos LFO Speed from a pot will run faster at the same knob position
  • Room Reverb decay roughly doubles at the same Reverb Time; Allpass controls capped at 0.7 and Micro-Stutter Wet Level at 1.0, above which they distorted
  • Compiler/assembler: fixed dead-store elimination deleting live state at optimization level 2, @if conditions silently dropping guarded code, out-of-range branches encoding silently, and duplicate labels colliding
• Debugger: live reload — edit assembly or block parameters while running
• Debugger: fixed a session leak and large performance improvements in the scope
• Fixed the spectrogram not drawing until the panel was resized
• Block diagram editor: ports snap when wiring, and each modified parameter has a "Reset to Default" button
• Removed fv1.hardware.regCount and fv1.hardware.delaySize settings — both are fixed by the FV-1 instruction encoding and were never adjustable in practice

Bump fv1-core. Numerous fixes to blocks. Much better simple reverb block. Fixed an optimizer bug.

• Bump fv1-core to pick up fixed SIN/COS LFO and 8-Tap Delay
• Add an MCP server for AI-patch generation

Update some dependencies. Try publishing to the Marketplace via new mechanism.

Cleanup tests. Pick up an assembler bugfix.

Fixes a bug in the simulator related to the RMPA instruction

• Add an export command for the MOD plugin and easy-spin-effects
• Fix up error messages to be more obvious when no programmer is attached

Bump fv1-core. Fixes plate reverb (and likely other blocks) when only one output was connected.

Overhauled simulator now mirrors https://easy-spin.audiofab.com and is much easier to use! This new simulator also serves as your bank editor.

The old workflow is still available for low-level debugging.

Refactor to use fv1-core for common bits

• Fix an LFO delay memory wrap bug in the simulator
• Visualizations of delay memory reads